<< Back

Installing the brake disc is a technical job. Not only should you pay attention to safety during operation, but it cannot be completed by one person. Let's take a look at the detailed steps for installing the brake disc.

1. Start disassembling the rear wheel assembly. Here, it should be explained that special tools are needed to disassemble the rear wheel bearing cover! If you use a flat-blade screwdriver to pry, the seal of the bearing cover will be damaged. If water enters, you should replace the bearing with a new one.

2. Start disassembling the rear brake disc baffle. This is what it looks like after disassembling the rear wheel bearing. At this time, clean the dust in the bearing sleeve. Install the new brake disc baffle, tighten the rear wheel bearing, and press the bearing cover.

3. Install the wheel cylinder bracket, install the brake pads, and press the wheel cylinder. Tighten the screws between the wheel cylinder and the bracket. Be sure to tighten them. This is the key!

4. After tightening each bolt, press the wheel hub to complete the operation.